Bending the plywood has been challenging with the curvature of the inside of the boat and trying to make it fit good and tight so I don’t have any large gaps to contend with.
Put in what I call the toe kick; it’s the board that goes from the shelf to the bottom of the boat and I added a piece of trim in between to help reinforce the shelf above and it also dresses it up a little bit.
I started on the other side and got the top framed up. I’m working on the shelf and got the wall done. If you build something like this, you can learn from what I’ve learned – nothing is square on a boat! Lol.
At the back of the boat bar, I have built an area that would accommodate either an ice machine, a hand sink or something of that nature. To the left, that last section is framed up to where you can actually install a 5 foot beer box.
Jack